Effect of Ti6Al4V Substrate Manufacturing Technology on the Properties of PVD Nitride Coatings
M. Walczak, K. Pasierbiewicz, M. Szala
Lublin University of Technology, Faculty of Mechanical Engineering, Department of Materials Engineering, Lublin, Nadbystrzycka 36, 20-618 Lublin, Poland
Full Text PDF
Titanium alloys can be fabricated by additive manufacturing techniques, which makes it possible to produce machine components of complex geometries that would be difficult to produce by standard methods such as machining, forming, and casting. Although titanium alloys have a high strength-to-weight ratio, their tribological characteristics are insufficient. For this reason, ceramic coatings with high tribological properties, e.g., PVD coatings, are frequently deposited on titanium alloys. Still, the surface layer properties of Ti6Al4V alloy produced by the direct metal laser sintering differ from those exhibited by this alloy when produced by the standard means in terms of microstructure, internal stresses, texture, and porosity. In light of the above, the objective of this study was to determine the relationship between the surface layer microstructure, morphology, and mechanical properties of the direct metal laser sintering produced Ti6Al4V alloy and the adhesion of PVD nitride coatings. The test samples of Ti6Al4V alloy were fabricated by two different techniques, i.e., conventional manufacturing from wrought material (in the annealed state) and direct metal laser sintering. Two different PVD coatings, AlTiN and TiAlN, were deposited by magnetron sputtering on a titanium substrate. Internal stresses were measured by the X-ray diffraction and sin2(ψ) method. The microstructure was examined by optical microscopy. Coating thickness was measured by the ball crater test. After that, coating nanohardness was measured by the Olivier-Pharr method, and coating/substrate adhesion was assessed by the scratch test method. The results showed that the PVD coatings deposited on the direct metal laser sintering substrate had considerably higher adhesive properties, which resulted primarily from the better fit of the Ecoating/Esubstrate ratio and higher compressive stresses. Scratch test results demonstrated that all coatings deposited on the direct metal laser sintering substrate had a nearly 25% higher critical load Lcr (which was a measure of adhesion) than the same coatings deposited on the conventionally manufactured substrate. In addition to that, the cohesive damage mechanism was observed for the latter.

DOI:10.12693/APhysPolA.142.723
topics: titanium alloy, additive manufacturing, hard coatings, physical vapour deposition (PVD)